Pneumatic 30 Liter Wind Grease Pump is a pump used inside buildings.

The installation area must be selected in such a way that correct operation can be ensured. Pneumatic pumps must be used with maintenance units.

Pneumatics 30 Liter Grease Pump The intended wind pump is a pump used inside the building.

The installation area must be selected in such a way that correct operation can be ensured. The pneumatic pump must be used with a maintenance unit, otherwise the warranty will not apply.

It is also important to understand in ensuring that the pressure regulating valve is used when the pump is operated.

Set the pressure to 6 bar to reach the recommended pump operating pressure.

This will help prevent possible equipment damage, pipe leaks and protect the pump. The new installation line should be cleaned to avoid any remnants of metal powder damaging the individual components inside the pump.

When replacing the container, protect the infiltration tube well to ensure that the infiltration tube is not contaminated by dirt particles, such as metal parts, debris, etc. which will further contaminate the lubricant in the new container.

This will help prevent possible equipment damage, pipe leaks and protect the pump. The new installation line should be cleaned to avoid any remnants of metal powder damaging the individual components inside the pump in case the accessories are properly connected to the pump. Here are the Operating Instructions Pompa Pneumatic Grease, is as follows:

1. Remove the dust cover from the container and insert the follower plate at a slight angle. Then push the follower plate towards the grease until the grease comes out of the center hole.
2. Install the stabilizer mounting bracket on the grease container and set the stabilizer mounting bracket over the center opening of the follower plate.
3. Push the dust cover into the grease pump pipe and insert the pipe through the stabilizer mounting bracket and through the follower plate into the grease container.
4. Attach the grease hose with all its appropriate accessories (swivel joint, high-pressure grease gun, etc.) to the pump exit.